The Real Reason Your Stencils Keep Wiping Off

If your stencils keep wiping off, it’s not bad luck — it’s technique. Beginners struggle with stencil longevity because they miss one of these crucial steps. (OBV. you should be using Electrum's Stencil Primer & Repositioner - if you are not - that's your first mistake) 1. Your Client’s Skin Wasn’t Prepped Properly Prep is everything. Correct prep: • shave clean• wipe with a gentle cleanser• remove oils / lotion• dry completely before applying the stencil Any moisture → stencil slip. 2. You’re Using Too Much or Too Little Product Stencil Primer is designed to be used thin. Too much: it turns into a slip-and-slideToo little: stencil won’t transfer deeply Use a thin, even layer — almost invisible. 3. You’re Not Letting the Primer Get Tacky This is where most apprentices mess up. It needs to dry until tacky. Not wet.Touch it lightly — if it feels sticky, it’s ready. 4. You’re Not Applying Enough Pressure You’re not placing a sticker — you’re transferring information. Apply firm pressure for 10–20 seconds.Make sure the entire stencil touches the skin. 5. You’re Not Letting the Stencil Dry Fully Stencil drying is not optional. Minimum: 10 minutesIdeal: 15–30 minutesLarge pieces: 45+ minutes The longer it sits, the stronger it holds. Use that time to set up your station. 6. You’re Scrubbing Too Hard While Tattooing If you wipe like you’re trying to remove car grease: • stencil smears• lines blur• design disappears Use small, controlled wipes with a gentle cleanser. 7. You’re Stretching Skin in the Wrong Direction Stretching against the stencil can distort the lines. Stretch with the natural flow of the design. 8. You’re Leaning Your Hand on the Stencil Your hand oils break down the transfer. Float your hand until you’ve tattooed far enough away that resting is safe.